Futaba 8J User Manual
Page 35
34
Model data transmission (MDL-TRANS): Transmission of model data is possible with T8J transmitters. Data transfer is
performed on radio.
The present model is MDL-TRANS with each transmitter. As for a receiving side, the present model data is rewritten.
*T8J does not carry out normal operation during data transfer.
Always check servo direction prior to every flight as an additional
SUHFDXWLRQ WR FRQ¿UP SURSHU PRGHO GDWH KRRN XSV DQG UDGLR IXQFWLRQ
NOTE: 0'/75$16 EHWZHHQ WZR 7- UDGLRV VKRXOG EH SHUIRUPHG ZLWKLQ D
PHWHU UDQJH
GOAL of EXAMPLE:
STEPS:
INPUTS:
MDL-TRANS
is performed.
Open MDL-TRANS function.
for 1 second.
to MDL-TRANS.
The transmitting side is turned on.
Select TRANSFER or RECEIVE.
Data is transmitted.
to Execute.
for 1 second .
Data Trans is for 10 seconds.
T8J of a receiving side is set to RECEIVE,
and the same procedure is followed.
T h e c o m p l e t i o n o f t r a n s m i s s i o n
"Complete"
Transmission failure
"Failure"
Close.
Where next?
SELECT
a different model to edit or delete: p. 27.
NAME
the model: p. 29.
GOAL of EXAMPLE:
STEPS:
INPUTS:
Change BATT TYPE from 4CELL to 5CELL. Open the menu, then open PARAMETER
submenu.
for 1 second.
to PARAMETER.
Go to BATT TYPE and change setting.
(Ex: 5CELL)
to BATT TYPE.
to 5CELL.
Close.