Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 82)

82
● Select the function name
and return to the Model
menu by touching the
RTN button.
DUAL RATE The angle and curve of each stick function can be set. [All model types]
Dual rate function is used to adjust the amount
of throw and the operational curve of the stick
functions (aileron, elevator and rudder) for each
flight condition or up to 5 rates for each function.
For airplane type, it is also possible to adjust the
operational curve of the throttle function.
This is normally used after the End Point
programming has been completed to define the
maximum throw. When mixing is applied from one
channel to another channel, both channels can be
adjusted at the same time by adjusting the operation
rate through the dual rate function.
Neutral position of the dual rate curve can be
set.
Dual rate curve of FLAP, FLAP3, BUTTERFLY,
and CAMBER function can be set. (Airplane/
Glider)
*FLAP3 and BUTTERFLY are glider only functions.
*EXP rate setting is not performed at the FLAP, FLAP3,
BUTTERFLY, and CAMBER functions.
*Individual switch setting is not performed at the FLAP,
FLAP3, and BUTTERFLY, CAMBER functions. (Condition
switching only)
● Select [DUAL RATE] at the Model menu and access
the setup screen shown below by touching the
RTN button.
(Currently selected circuit #)
●Function selection
●Neutral position
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
●Left/right (up/down) rate
●Operation curve (left/right, up/down)
●Switch selection
[Airplane]
[Helicopter/glider]
●Switch mode
selection
●Switch mode
selection
●Condition selection
●Switch selection
*Up to five rates for each function