Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 24)

24
Up/Down timer (ST1, ST2)
• Timer is displayed here.
Touch the RTN button at the [xx]:[xx.x]
item to start/stop the timer.
• Use the cursor to highlight this, then
touch the RTN button at the ST1 or ST2
item to call the timer set-up screen.
*See the description at the back of this manual.
Home screen
Digital trim (T1 to T4)
• Trim position is displayed here.
• You can select the display unit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
Model Name
• The model name that
is currently used is
displayed here.
• Use the cursor to
highlight this, then
touch the RTN button
to call the model
select set-up screen.
User's name
System timer
• This shows the accumulated time since
the latest reset. (Hour):(Minute)
• Use the cursor to highlight this, then
touch the RTN button for one second
to reset the system timer.
Use the touch sensor to select the following display area to call each setting screen, and touch the RTN
button. The setting screen appears.
RF indicator
Battery Indicator
• When the battery voltage
reaches 6.8V, the alarm will
beep. Land your aircraft
immediately.
FASST mode
• FASST mode is displayed here.
• Use the cursor to highlight this,
then touch the RTN button
to call the frequency set-up
screen.
2 nd Home screen
• Touch the RTN button at
the clock icon to call the
2 nd home screen (large
size timer).
Model timer
• This shows the accumulated time
since the latest reset. (each model)
(Hour):(Minute)
• Use the cursor to highlight this,
then touch the RTN button for one
second to reset the model timer.
Key lock
• Touch the S1 button for one second
to lock/unlock the key operation.
In the key lock mode the key icon is
displayed here.
Model type
SD card indicator
Condition name (Heli/Glider)
• In the normal condition, move the
cursor to the condition name and
touch the RTN button. The condition
name is changed and blinked.
I t i s p o s s i b l e t o o p e r a t e t h e
digital trim other than the normal
condition.
VPP condition # (Air)
• When VPP function is assigned to a
channel, the current VPP condition
# is displayed here.