Futaba 8FGAS, 8FGHS 2.4GHz - Manual (Page 131)

131
● Select the function name
and return to the Model
menu by touching the
RTN button.
GYRO mixing
This function used to adjust gyro sensitivity.
The sensitivity and operation mode (Normal mode/
AVCS mode) can be set for each condition.
The gyro sensitivity can be switched with each
condition or the switch. (5 sensitivities)
*Compatible with 3 axis gyro(CGY750).
● Select [GYRO] at the Model menu and access the
setup screen shown below by touching the RTN
button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
Note: When using the [Gyro2]/[Gyro3] function,
assign [Gyro2]/[Gyro3] to any channel on the
function screen.
Always set to [--] both (Control) and (Trim) for
the [Gyro] function at the Function menu in
the Linkage menu.
(Currently selected condition name)
●Mode selection:
[AVCS]/[NORM]
●Gyro type selection:
[GY]/[NORM]
●Setup screen selection
●ON: (initial setting)
●Fine tuning VR settings
●Gyro sensitivity adjustment
●Condition/Switch selection
●The edit conditions can be
changed by touching the
S1 button.
*When the rate switching setting of
all the gyros is “Switch”, the edit
conditions are not displayed.
●The edit rate can be changed by operating
the edit rate button.
*When the rate switching setting of all the gyros is
“COND”, the edit rate button is not displayed.
●When the GYRO function button is selected,
each GYRO detailed setting screen
appears.