Futaba 4GRS - Manual (Page 92)

Communication port
ESC receiver connector
Connecting ESC receiver
connector to the transmitter
Communication port
Connection diagram
92
Fu
nc
tio
n
(Preparation)
-Connect the T4GRS and ESC in accordance with the connection
diagram, and connect the battery to ESC.
1
Set the transmitter power switch to the display side (DISP).
Display the MC LINK function screen in the above manner.
Using the ESC Link function
ESC Link Function "MC LINK"
This is a special function which lets you set the contents of the Link software in
Futaba speed controller (ESC), MC960CR, MC940CR, MC950CR, MC851C,
MC602C, MC402CR, etc, with variable frequency and other data changes at the
T4GRS transmitter. However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter. The T4GRS
power switch is set to the display side. Use the various optional servo extension
cords according to the distance between the transmitter and ESC. The last data read
from ESC to T4GRS or the last data written from T4GRS to ESC is saved to the
T4GRS. Since the data for each model memory can be saved, the data of up to 40
models can be saved.
-When the T4GRS battery voltage drops, the display switches to low battery display. Therefore, use this function when there
is ample battery capacity remaining.
-Also connect the battery at the ESC side.
-Note: Do not read to the T4GRS an MC940/960CR whose speed was set to over 99990rpm by Link software side Boost
Angle rpm setting.
ESC Link Function "MC LNK"
2
(ESC read)
Execute this function to read the connected ESC type and the data currently set at the
amp. To save the ESC data to the T4GRS, rewrite the read data.
When you want to write the data saved in the T4GRS to an ESC of the same type, ex-
ecute the following "WRITE"(write) without executing "READ"(read).
(MC LINK screen)
Press
(DISP MENU screen)
Press
Select
"MC LINK"
MC402CR MC602C MC851C MC950CR
MC960CR MC940CR