Dual esc mixing "dual esc, Fu nc tio n, Throttle system) – Futaba 4GRS User Manual

Page 82

Press

(HOME screen)

(MENU 1 screen)

(DUAL ESC screen)

(MENU 2 screen)

Press

Select
"DUAL ESC "

The function select switch
screen can be displayed
from this screen.

tio

Dual ESC mixing "DUAL ESC"

This function is mixing used with crawlers and other 4WD type vehicles and uses the

2nd CH to control the front motor controller and the 4th CH to control the rear motor

controller.
Front drive only, rear drive only, or both front and rear drive can be selected using any

programmed DT (digital trim) button.

Dual ESC Mixing "DUAL ESC"

(Throttle system)

(Preparation)
- This function is used to switch between front
drive/4WD/rear drive using one of the dials
(trim). Set the desired dial (trim) for this func-
tion using the SW/DIAL screen.

(Dual ESC setting)

Select the setting item "MODE" using the (JOG) button up
or down operation. Set the function by pressing the (+) or (-)
button.

"INH" : Function OFF
"ACT" : Function ON

Dual ESC mixing adjustment

Function ON/OFF (MODE)
INH, ACT

Display "DUAL ESC" function screen by the following method:.

When the 4th CH was set to ACT at Brake Mixing or when CPS Mixing is used, Dual

ESC mixing cannot be used.

Setting Special mixings

Setup items

MODE : Function ON/OFF
RATE :

4ch rate (Rear side)

MXMD : Mix mode
TRIM : Trim mode

Function SW
ESC-MD

Select button
- Select with the (+) or (-) but-

tons.