Flintec FT-12 Manual User Manual
Page 20
FT-12 Technical Manual, Rev. 1.35 November 2010
Page 20 of 44
will show the [WAıt ] message during the span adjustment under load. Approximately 10 seconds later
the display will show the [SAvE ] message. You can confirm the “Save span adjustment under load” by
pressing
7 M
EMORY
O
PERATIONS
7.1 ID
Memory
FT-12 has two ID codes and the capability to assign clear-text names to them for print out. There are also 99 ID
memories which can be shared between the two IDs in any way. The IDs can either be entered via related keys
or can be downloaded via serial port in host mode (e.g. by using the FLINTEC IndFace software).
To call any ID from the memory you have to press the
Now the [ıd --] is prompted. Enter the ID code (from 1 to 99) and confirm with
After selecting the desired ID, the indicator will return to the weighing mode. If you want to return to the weighing
mode without calling any ID, you can simply press the
After calling any ID from the memory, you can print the alphanumeric ID code on the printout. (see parameter
[043] and [044]). If you download ID headers to FT-12, the alphanumeric ID headers can be printed instead of
the default ID headers.
7.2 Preset Tare Memory
99 numerical tare values can be stored within FT-12 and can be recalled at any time as preset tare.
To store a numerical tare value into the memory you have to press the
prompted on the display. You need to press the
which means that you have reached the 1
st
code of the preset tare memory. You can directly enter the code
number of the desired preset tare or you can search for the preset tare code by <
>
and
<
>
keys.
After finding the desired code you can access it by pressing
display. Enter the the new preset tare value with numerical keys, then confirm with
the next tare code. Pressing the
For taring with any preset tare value from the memory you have to press the
Now the [Pt --] code is prompted on the display. You should type the related preset tare code (from 1 to 99)
with numerical keys and confirm with
short period, then the indicator tares the scale and the net weight is shown on the display.
You can return to the weighing mode without selecting any preset tare code by pressing the
If the selected tare code is empty, the [EMPtY] message will appear on the display. If the tare value is zero or
greater than the scale capacity, the [Err Pt] message appears on the display. The messages can be confirmed
by pressing
7.3 Setpoint
Memory
FT-12 has 9 setpoint groups with 3 setpoint values for each. The setpoints can only be used by selecting from
the memory. Therefore the setpoints have to be stored to the memory first.
First you need to press the
[MeMorY] message is shown on the display the [SPN xx] will be displayed. Here the first digit is the group
number; the second digit is the setpoint number in that group. For example [SPN 12] means the 2
nd
setpoint of
the 1
st
group. Here you can search between setpoints by <
>
and
<
>
keys and confirm the desired setpoint
with
After entering the new setpoint value with numerical keys, you can confirm the entered value and go to the next
setpoint by pressing
changes.
To call a setpoint group from the memory, you have to press the
The [SP -] message will appear on the display. Here you have to enter the setpoint group number (from 1 to
9) and confirm it with
numbers and the indicator will return to the weighing mode. You can also return to the weighing mode without
selecting a setpoint group by pressing the