Flintec FT-11D - Manual (Page 50)

FT-11(D) Technical Manual, Rev. 1.35 November 2010 Page 50 of 52
Appendix 8: Parameter’s Default Table
Parameter Factory defaults FT-11 FT-11D
0-- Interface x x
00- Serial Interface 1 x x
0 Data format 2 = Printer x x
1 Baud rate 3 = 9600 x x
2 Handshake 0 = Disable x x
3 Address 0 x x
4 Data length and parity 0 = 8 bit, no parity x x
5 Checksum 1 = Enable x x
01- Serial Interface 2 x x
10 Data format 0 = Disable x x
11 Baud rate 3 = 9600 x x
12 Handshake 0 = No x x
13 Address 0 x x
14 Data length and parity 0 = 8 bit, no parity x x
15 Checksum 1 = Enable x x
02- Serial Interface 3 x x
20 Data format 0 = Disable x x
21 Baud rate 3 = 9600 x x
22 Handshake 0 = Disable x x
23 Address 0 x x
24 Mode 0 = RS232C x x
25 Data length and parity 0 = 8 bit, no parity x x
26 Checksum 1 = Enable x x
03- Ethernet / Profibus / ProfiNet / CANopen x
30 Ethernet data format 0 = Disable x
31 Ethernet address 0 x
32 Profibus data format 0 = 32-bit integer x
33 Profibus adress 0 x
34 CANopen data format 0 = 32-bit integer x
35 CANopen Adresse 0 x
36 ProfiNet data format 0 = 32-bit integer x
04- Printer x x
40 Print out format 2 = Multi line x x
42 CN (Consecutive number) 1 = Will be printed x x
45 Minimum print 20 kg x x
46 Print control 0 = With Print Key x x
47 Line feed 11 = 1 LF + 1 LF x x
48 Form feed 0 = No x x
49 Quantity of copies 1 x x
1-- Configuration x x
11- Start Up x x
111 Auto power off 0 = Disable x x
112 Store Tare at power off 0 = Disable x x
113 Auto tare clear 0 = Disable x x
114 Buzzer active? 0 = Disable
115 Key lock 0 = Disable x
12- Filter x x
120 Filter FT-11: 7 / FT-11D: 0 x x
13- Digital I/0 x x
130 Outputs 0 = Disable x x
131 Input 1 0 = Disable x x
132 Input 2 0 = Disable x x
133 Input 3 0 = Disable x x
14- Entries x x
142 Label no. entry x x