EVCO EPV4GBR Hardware manual - Manual (Page 10)

Evco S.p.A. Vgraph | Hardware manual ver. 1.01 | Code 114VGRAHWE01
page 10 of 22
4. CONFIGURATION
4.1. Preliminary information
The following table shows the main meaning of the buttons.
Button Meaning
button escape (hereinafter called “button ESC”)
button move to left (hereinafter called “button LEFT”)
button increase (hereinafter called “button UP”)
button decrease (hereinafter called “button DOWN”)
button move to right (hereinafter called “button RIGHT”)
button confirm (hereinafter called “button ENTER”)
4.2. Configuring the interface
To gain access to the procedure operate as follows:
1. Switch off the power supply.
2. Keep pressed buttons ESC and RIGHT.
3. Switch on the power supply.
4. When the display shows the following menu (hereinafter called Main menu) release buttons ESC and RIGHT:
V-Graph
Parameters
Contrast
CAN Network
Modbus
Info
Real date and time
It is also possible to show the Main menu operating as follows:
5. Make sure the power supply is switched on.
6. Keep pressed 2 s buttons LEFT and ENTER: the display will show the following menù (hereinafter called Network Status menu):
Network Status
Loc 99 OK
> >
(back to the
Main menu)
1 1 - > >
2 0 - > >
3 0 - > >
4 0 - > >
5 0 - > >
7. Press and release button ENTER: the display will show the Main menu.