Compex Technologies NP25G 6C - Manual (Page 32)

Page 27
Configure the Advanced WLAN
Settings
Follow these steps to change the radio settings of the router.
1. Click on WLAN Setup from the
CONFIGURATION menu.
2. Select Advanced.
1. Set the Beacon Interval (the time
lapse between every beacon sent)
to any value between 20 and 1000.
It is preset as 100 seconds.
2. Set the Data Beacon Rate from 1 to
16384.
This determines how often the
beacon should contain a
Delivery
Traffic Indication Message ( DTIM )
that tells power-save clients that a
packet is waiting for them. Is it preset
to 1.
3. Set the RTS/CTS Threshold from 256 to
2346.
It is preset to 2346.
4. Set the Frag Threshold from 256 to
2346.
It is preset to 2346.
5. Transmission Power Control (TPC)
offers the flexibility to set the Transmit
Power . (802.11h compliant)
It is set to Maximum by default, but
should be reduced if there is more
than one unit using the same
channel frequency.
It can be set from Minimum to
Maximum, 1dBm to 20dBm, in
increments or 1dBm per step.
1. Click
Apply .
Changes will be enabled after reboot.
1
2
3