Dynaflite DYFA1009 - Manual (Page 5)

*A flat, durable, easy-to-handle sanding tool is a
necessity for building model airplanes. Great Planes
makes a complete range of Easy-Touch™ Bar Sanders
and replaceable Easy-Touch adhesive-backed
sandpaper. For the Piece 0' Cake all that is required
is the short 5-1/2" Bar Sander (GPMR6169) and
two assortment packages of adhesive-backed
sandpaper (GPMR6189).
For future reference, here's a list of Easy-Touch Bar
Sanders and adhesive-backed sandpaper:
5-1/2" Bar Sander (GPMR6169)
11 "Bar Sander (GPMR6170)
22" Bar Sander (GPMR6172)
Assortment pack of 5-1/2" strips (GPMR6189)
12' Roll of adhesive-backed sandpaper,
80-grit (GPMR6180)
150-grit (GPMR6183)
220-grit (GPMR6185)
Machine screws are designated by a number,
threads per inch and a length.
For example 2-56 x 3/8"
When you see the term "test fit" in the
instructions, it means you should first position the
part on the assembly without using any glue,
then slightly modify or "custom fit" the part as
necessary for the best fit.
Whenever just "epoxy" is specified you may use
either 30-minute epoxy or 6-minute epoxy. When
30-minute epoxy is specified, it is highly
recommended that you use only 30-minute epoxy
because you will need either the working time
and/or the additional strength.
COMMON ABBREVIATIONS
Fuse = Fuselage
Stab = Horizontal Stabilizer
LE = Leading edge (front)
TE = Trailing edge (rear)
Ply = Plywood
" =Inches
• There are two types of screws used in this kit:
Sheet metal screws are designated by a number
and a length.
For example #2 x 3/8"
Balsa Basswood Plywood
5