Dynaflite DYFA1009 - Manual (Page 21)

Q 3. Use a sharp hobby knife and a straightedge to
cut 1 /8" off the front of only the right fuselage side.
U 6. Glue a 1/4" x 30" balsa triangle stick to the
inside right fuselage side top as shown on the plan.
Note that the stick "ends" approximately 2-1/4"
from the back of the fuselage and you will have to
cut the stick into two pieces at the front of F3. Do not
glue a triangle piece to the fuselage side at the top
of the hatch compartment until instructed to do so.
CJ 4. Push a large T-pin through the punch marks that
are on the outside of the right fuselage side to transfer
the punch marks to the inside. Use a straightedge to
draw a line with a ballpoint pen connecting the punch
marks that indicate where the formers are located on
the inside of both fuselage sides.
Q 5. Make two 2-1/2" long servo rail supports
from the remainder of the 1/8" x 1/4" balsa stick
you used to make fuselage formers F3 and F4. Glue
the supports to the inside of both fuselage sides in
the location shown on the plan and in the photo.
LI 7. Glue a 1 /4" x 30" balsa triangle stick to the
bottom inside of the right fuselage side as shown on
the plan. The front of the stringer extends all the way
to the front of the fuselage and like the top triangle
stick, is cut into two pieces at the front of F3 and ends
approximately 2-1/4" from the back of the fuselage.
Q 8. Glue two more 1/4" x 30" balsa triangle
sticks to the inside of the left fuselage the same way
as the right.
JOIN THE FUSELAGE SIDES
Q 1. Test fit but, do not glue, all three formers to the
right, then the left fuselage side. If necessary, adjust the
45 degree angle on the corner of each former so the
sides of the formers fully contact the fuselage sides.
21