Pair connection (slave), From the start menu, select the run command – Comtrol DM Primo for Pair Connect and Raw Connect Methods User Manual
Page 9
DeviceMaster Primo for Pair and Raw Connect Methods
9
Pair Connection (Slave)
Pair Connection
(Slave)
Setting the parameters for a Pair Connection requires two procedures. Use the
previous procedure, Pair Connection (Master), to complete the connection.
1.
From the Start menu, select the Run command.
2.
Type Telnet plus the slave Primo IP address, and select the OK button.
3.
Confirm that it is a vt100 session, and press the Enter key.
4.
Use the arrow keys to select the serverConfig menu item, and press the
Enter key. Review the values.
5.
Press the Esc key to return to the menu. Use the arrow keys to select the OP-
mode menu item and press the Enter key.