Comtrol DM Primo for Pair Connect and Raw Connect Methods User Manual
Page 14

DeviceMaster Primo for Pair and Raw Connect Methods
14
TCP Server
6.
Select the an item on the Application list, and press the Enter key to display
the connection options.
7.
Select the Raw Connection (TCP Server) item from the pop-up box. Press
the Enter key.
8.
From the More Setting list, highlight the Select for more setting item, and
press the Enter key.
9.
Set up a TCP port number, Destination IP address, Inactivity time, and
TCP alive check time, as the following describes.
TCP port
Enter the desired TCP port number.
Destination IP address
Enter the IP address of the remote network card which will be sending raw
data to your DeviceMaster Primo. To allow access for all hosts, leave the IP
address blank.
Inactivity time
Enter the amount of time, in milliseconds, that will be allowed to expire before
an inactive connection is shut down. Inactive connection stands for no data in/
out via a serial port during the period, after that amount of time the system
software will reset the serial port.
Alive timeout
Enter the amount of time, in minutes, that will be allowed to expire before a
TCP/IP connection is shut down.