Pair connection mode, Pair connection (master), From the start menu, select the run command – Comtrol DM Primo for Pair Connect and Raw Connect Methods User Manual
Page 5
DeviceMaster Primo for Pair and Raw Connect Methods
5
Pair Connection Mode
Pair Connection Mode
You use a combination of the Master and Slave Pair Connection operating modes
to connect two DeviceMaster Primo units. Use the following two procedures.
Pair Connection
(Master)
1.
From the Start menu, select the Run command.
2.
Type Telnet plus the master Primo IP address, and select the OK button.
3.
Confirm that it is a vt100 session, and press the Enter key.
LAN/WAN
Ethernet Hub
Ethernet Hub
Terminal
Printer
Pair Connection Example
DeviceMaster
Primo (Master)
DeviceMaster
Primo (Slave)