Nwc/third-party initialization and configuration – Comtrol RocketModem Driver Installation for Novell NetWare User Manual
Page 5
NWC/Third-Party Initialization and Configuration
5
NWC/Third-Party Initialization and Configuration
Follow these steps:
1.
Load the driver manually, using the command line discussed in
2.
Add the load commands to the
AUTOEXEC.NCF
file, so that they are executed each time the system is
restarted.
3.
At the command prompt, type load install. The Installations Options menu displays.
4.
Select NCF files options. The Available NCF Files Options menu displays.
5.
Select Edit AUTOEXEC.NCF file.
6.
Scroll down until you find the load commands.
7.
At the end of the load commands, add a load line for each board, using the syntax in the
table. Remember, lines initializing PCI boards must be executed before lines initializing ISA
boards.
8.
Save the changed file, then press Esc until you exit.
9.
Go to the appropriate procedure for your installation:
•
NetWare Connect Configuration for NetWare 4.x
•