Comtrol RocketModem Driver Installation for Novell NetWare User Manual

Page 14

NIAS/MPR Installation and Configuration for NetWare 4.x

This discussion assumes the following:

•

You have installed the RocketPort or RocketModem board(s) in the server

•

The board(s) have passed the hardware diagnostic

•

You have installed the driver (AIORCKT.NLM)

•

You have determined which I/O addresses are used by the boards you have installed

•

You have not loaded the driver manually, using the load aiorckt command

The inetcfg module provides the proper mechanisms for loading and configuring the driver. If necessary, down
and restart the server to make sure that the driver is not loaded.

The following instructions assume a single RocketPort or RocketModem board, but the process is similar
when multiple boards are installed. Follow these steps:

At the server console, enter load inetcfg.The Internetworking Configuration menu displays:

Select Boards. The list of configured boards displays: