Comtrol eCos - Manual (Page 235)

Chapter 5. Installation and Testing
Enable coprocessor access
Drain write and fill buffer
Setup PBIU chip selects
A1
Enable the Icache
A2
Move FLASH chip select from 0x0 to 0xF0000000
Jump to new FLASH location
A3
Setup and enable the MMU
A4
I2C interface initialization
90
Wait for I2C initialization to complete
91
Send address (via I2C) to the DIMM
92
Wait for transmit complete
93
Read SDRAM PD data from DIMM
94
Read remainder of EEPROM data.
An error will result in one of the following
error codes on the LEDs:
77 BAD EEPROM checksum
55 I2C protocol error
FF bank size error
A5
Setup DDR memory interface
A6
Enable branch target buffer
Drain the write & fill buffers
Flush Icache, Dcache and BTB
Flush instuction and data TLBs
Drain the write & fill buffers
SL
ECC Scrub Loop
SE
A7
Clean, drain, flush the main Dcache
A8
Clean, drain, flush the mini Dcache
Flush Dcache
Drain the write & fill buffers
A9
Enable ECC
AA
Save SDRAM size
131