Comtrol eCos - Manual (Page 116)

Chapter 2. RedBoot Commands and Examples
Format Description Example
operand A simple value; some commands
require a single parameter for which
an additional
-X switch would be
redundant. In the example, JFFS2 is
the name of a flash image. The
image name is always required, thus
is no need to qualify it with a switch.
Note that any un-qualified operand
must always appear at the end of the
command.
RedBoot> fis delete JFFS2
The list of available commands, and their syntax, can be obtained by typing help at the command line:
RedBoot> help
Manage aliases kept in FLASH memory
alias name [value]
Set/Query the system console baud rate
baudrate [-b < rate>]
Manage machine caches
cache [ON | OFF]
Display/switch console channel
channel [-1| < channel number>]
Display disk partitions
disks
Display (hex dump) a range of memory
dump -b < location> [-l < length>] [-s]
Manage flash images
fis {cmds}
Manage configuration kept in FLASH memory
fconfig [-i] [-l] [-n] [-f] [-d] | [-d] nickname [value]
Execute code at a location
go [-w < timeout>] [entry]
Help about help?
help [ < topic>]
Set/change IP addresses
ip_address [-l < local_ip_address>] [-h < server_address>]
Load a file
load [-r] [-v] [-d] [-c < channel>] [-h < host>] [-m {TFTP | HTTP | {x|y}MODEM | disk}]
[-b < base_address>] < file_name>
Network connectivity test
ping [-v] [-n < count>] [-t < timeout>] [-i < IP_addr]
-h < host>
Reset the system
reset
Display RedBoot version information
version
Display (hex dump) a range of memory
x -b < location> [-l < length>] [-s]
12