Toshiba TEC MA-1700 - Manual (Page 82)

E01-11040
Combination Reports
Multiple reports can be programmed to be issued in one operation sequence. The following are
reports programmable for combinations (max. 5 reports in one table, max. 3 tables).
Please inquire this report programming of your TEC representative.
REPORT
NO. REPORT NAME AVAILABLE MODE
3 Financial Report X, Z, GTX, GTZ
4 All Cashier Report (GT only) GTX, GTZ
5 All Salesperson Report X, z .
6 Credit Company Sates Report X, GTX
7 Department Gross Profit Report X, GTX
8 Department Group Report X, GTX
9 Media Sales and In-drawer Report X,
10 Hourly Range Report X, Z,
11 All Department Report X, Z. GTX, GTZ
16 PLU Group Report X, Z,
KEY OPERATION: Mode Lock:
GT Lock:
X for Daily Read
Z for Daily Reset
GTX for GT Read
GTZ for GT2 Reset
1_J
[ATH-L]
Enter the Report Combination-ID No.:
None (simply depress [AT/TL]): Combination Report Table No. 1
1: Combination Report Table No. 2
2: Combination Report Table No. 3
NOTE: When the mode set for taking combination reports does not match the mode of a
report contained in the table, that report will be skipped.
If no combination reports data have been programmed, Combination Report Table
No. 1 (which is issued by depressing the [AT/TL] key aione) is auto-preset with
Report No. 11 (All Depts) and Report
3 (Financial). It will be active as Table No. 1
content unless no data are programmed for Table No. 1.
The report output order is determined by the order programmed in each table.
The drawer will open when a contained report is ruied to open the drawer.
- 1 4 -