Toshiba TEC MA-1700 - Manual (Page 135)

EO-11040
PLU PRESET-CODE KEY SETTING (Submode 27)
When there are any keys programmed as PLU Preset-code Keys on the ECR Keyboard, and/or when
the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may be preset to
each of those keys in this operation.
Any time outside a sale
Mode Lock : SET / GT Lock ; Neutral
27 {@/FOR]
i:
Repeatable for other keys.
I PLU Code I
Enter through Numeric
Keys on the ECR
Keyboard (Enter 0 to
close the key)
[KEY] > [AT/TL]
Depress the required
key on the ECR
Keyboard or on the PK-
2 Keyboard.
NOTES : 1, If the PLU Code entry is skipped and a [KEY] is simply depressed in the
above sequence, the preprogrammed PLU Code of the KEY will be
displayedr
2. A non-opened PLU Code (Le. PLU non-existent in the PLU fable fife) can be
set on a KEY; however, pressing the KEY in sale entries will result in an
error unless the code is opened in the PLU TABLE PROGRAMMING
operation, Submode 4.
3. If "0” is entered as PLU Code in the above sequence, the KEY will be
closed. Pressing the closed KEY in sale entry will not be processed.
ex) To set the following PLU Codes to the following KEYs on the ECR keyboard and/or
on the PLU Keyboard respectively :
Mode Lock to SET.
27 [@/FOR]
PLU Code
3
5
(Enter through
Numeric Keys on
ECR Keyboard)
I
3
5
[AT/TL]
(Depress the required
KEY on ECR or PLU
Keyboard)
I
[required key]
[required key]
Location Code (left side); refer to REMARKS 1
and 2 on the next page.
PLU Code assign^ to the key (right side)
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Thank you
Call a9ain
08-20-90 HO
N020 0003
K036 0005
0071 12:36TH
- 6 7 -