Direct character entry method, Qqczdcdcdgdcdcdqngdtiljhdczidgdddqb, Cdgdcdedcidgdaeaczlcdcidqoljgdhaaar – Toshiba TEC MA-1700 User Manual
Page 107: Acdedmcidczdcidgdcdcidmqqqipedgdaadcz, Czdgdgjcdcdgdgdcdcdczigj, Ocdczdbbsodss
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
E01‘11040
Direct Character Entry Method
Using Flat Keyboard finstalled as the ECR Main Keyboard):
-- Setting Mode Key Layout --
(Use the special sheet for this purpose and insert it between the film layers covering the
Flat Keyboard. This key layout is applicable to only certain submodes.)
Character Kays
in programming
Furtcticn Keys
in programming
QQCZICDQQQQaCinQCDOOBBBBOQCZ]
czdgdgjcdcdgdgdcdcdczigj
Q
ocdczdbbsodss
QQCZDCDCDGDCDCDQnGDtiLjHDCZIDGDDDQB
QQGDEDCDaQaaaaciDaaoEDCiDEDacDi
QQCDQQaacDaacDaac^GDCDGDaaciiZ]
aCDEDmCIDCZDCIDGDCDCIDmQQQipEDGDaaDCZ"
CDGDCDEDCIDGDaeaCZlCDCIDQOLJGDHaaar^
Character Keys:
Function Keys:
Simply depress the key to enter the character. (The [#) key should not be
followed.) The numerics 1 to 0 as the portion of character keys are entered
as characters 1 to 0 but not as codes for Department Codes, PLU Codes,
etc.
The One Double-sized Declaration (by depressing |X] (~ [@/FOR] once prior
to the required character) and the All Double-sized Declaration (by depressing
[X] twice before all the characters) are the same as in the CHAFIACTER
CODE ENTRY method.
These are function keys to be used in programming operations with the
Setting Mode Key Layout. The Numeric Keys here are used to enter
Department Codes, PLU Codes, etc. or numeric values as program data,
but not to enter the numerics as characters.
(Also refer to “Case 2 : When the ECR Keyboard is Flat Keyboard Tvoe" already stated.)
- 3 9 -