Toshiba TEC MA-1700 - Manual (Page 125)

E01-11040
DEPARTMENT LISTING CAPACITY SETTING (Submode 8)
The LC (Listing Capacity) setting is used to check an amount limit error. By setting the LC, an
amount entry (due perhaps to a mistake by the operator) will be prevented at the earliest stage (i.e.
an error will result on entering an excessive amount through the department key).
Any time outside a sale
Mode Lock : SET / GT Lock : Neutral
8 [@/FOR]
I
HALC
I I
LALC
I
LC for the individual
dept
( [SHIFT]) ->-[DEPT]
for the
shifted
depts.
- I
HALC
I I
LALC
I •
I___________ I
Common LC for all
depts
[AT/TL]
Repeatable for other departments
* HALC . . . . High Amount Listing Capacity (to be set in a 2-digít code.)
ex.)
I
3
I I
4
I
] 1
------- 4 digi
I___ Value of the
digit
indicate $39.99 ............... equal to or smaller than $39.99
digits
top
LALC .............. Low Amount Listing Capacity (to be set in a 2-digit code.)
ex.) I 2 I m
L
~ 2 digits
Value of the top
digit
indicates $0.29 .............. larger than $0.29
ex.) To set the following LCs.
Individual LCs (HALC $39.99, LALC $0.29) for Dept. 3.
Common LCs (HALC $99.99, LALC $0.19).
Mode Lock to SET, enter 8, depress [@/FOR],
3422 [DEPT 3] 9412 [AT/TLJ.
NOTES : 1. If the individual LC of a department is set, it
prevails over the common listing capacity.
2. To reset a listing capacity, enter 00 before the
[DEPT] key or the [AVTL] key in the above
operation.
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Thank you
Call again
11-20-90 «0
POS
03 HEAT 3422
9412
0022 10:59TH
- 5 7 -