Threading the bobbliy case – Kenmore 1030 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THREADING THE BOBBliy CASE
(D
(D
1.
To remove bobbin case from the
shuttle, raise needle to its highest
position.
2.
Open bed plate cover, and remove
accessory box.
3. Pull open latch of bobbin case.
4.
Pull bobbin case straight out of
shuttle.
5.
Insert bobbin into bobbin case mak
ing
sure
thread
is
coming
from
bobbin as shown.
6.
Pull thread through slot of case as
shown.
7. Pull thread under tension spring.
8.
Holding latch open, position case
into shuttle, and release latch. Case
should lock into place when latch
is released.
9.
Hold needle thread loosely in left
hand and rotate hand wheel toward
you one complete turn. Bring bob
bin
thread
up
by
pulling
upper
thread.