Placement of needle, Needles – Kenmore 1030 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
W|H*
NEEDLES
Use KENMORE needles. The size of
the needle should conform with the
size of the thread and both should be
suitable to the fabric (See next page).
Never use a bent needle or one with a
blunt point.
Fig. 1. shows you the exact length of
your needle. Be sure you never use
one in your machine that is not this
exact length.
You will find among your accessories
a -Q
nkhdlf
/
m
with blue shank. This
special needle is to be used when
sewing
certain
knits
and
certain
difficult
synthetic
fabrics.
If
you
experience skipped stitches in any of
your sewing, use
■■
qnkk
!)LK". .
PLACEMENT OF NEEDLE
Raise needle bar to its highest position
by turning the hand wheel toward you.
Loosen the needle clamp screw. Hold
ing the needle with the flat side away
from you,
slip the needle into the
needle bar. When it is in as far as it
will go, tighten the needle clamp screw
with a screwdriver.
18