Presser feet – Kenmore 1030 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PRESSER FEET
You have been given a variety of presser feet:
A. Zigzag Foot
B. Straight Stitch Foot
C. Satin Stitch Foot
D. Zipper Foot
E. Blindstitch Guide with shank
To change snap-on feet raise the presser
bar to its highest position by lifting the
presser foot lever. Press the front of
presser foot upward as high as it will go
and foot is released (See Fig. 1).
Place the desired foot on the needle
plate aligning the needle holes and lower
the presser foot lever. Press down on
presser
foot
thumb
screw
until
the
clamping shank (C) snaps on the foot
(See Fig. 2).
To change the one-piece presser feet,
raise the presser bar to its highest
position
by
lifting
the
presser
foot
lever. Loosen the presser foot thumb
screw, choose the proper foot, insert
from the front.
Tighten
the
screw
using
the
large
screw driver to make certain the foot
is secure.