beautypg.com

Special edge stitch, Mending, Darning – Kenmore 1030 User Manual

Page 38

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

!Lb.*

SPECIAL EDGE STITCH

SETTINGS

Special Stitch Dial - g
Stitch Width Control - 1 to 4
Stitch Length Control - Red Zone
Zigzag Presser Foot

Use zigzag stitching plate.

This is an attractive overcasting stitch
you may want to use on fabrics that
fray easily.

MENDING

SETTINGS

Special Stitch Dial - <:
Stitch Width Control - 4

Stitch Length Control - Red Zone

Zigzag Presser Foot

Use straight stitching plate.

To repair a straight or three-cornered
tear, position the tear under the needle

in such a way that the stitching catches
both sides of the tear. When mending
a three-cornered tear, stitch from each
end to the center. It is well to use a
piece of fabric under the tear for re­
inforcement.

37

DARNING

SETTINGS

Special Stitch Dial - Red Dot
Stitch Width Control - Red Dot
Pressure Regulator - 0
Feed Dogs - Up
No Presser Foot

Remove presser foot, stretch fabric be­

tween

embroidery

hoops

with

hole

centered. Draw the bobbin thread up

through the fabric by holding the top
thread and taking one stitch at the spot
where

you

wish

to

start

darning.

Lowering the presser bar, start sewing

at a slow to medium speed. Move the
fabric back and forth with a Steady
rhythm

to

cover

the

darning

area.

When it is covered, turn the fabric and
sew another layer of stitching across
the first layer of stitching.

This manual is related to the following products: