beautypg.com

Caring for the machine, Cleaning and oiling – Kenmore 1030 User Manual

Page 42

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

'4. Caring for the Machine-

Fig. 1

lever-

-lever

Shuttle Assembly

Shuttle Race Cover

pointed_
hook '

Shuttle

shuttle driver

Shuttle Race

CLEANING AND OILING

Fig. 1 Cleaning the feed dogs with a

brush.

To insure the best possible operation
of your machine, it is necessary to

keep the essential parts clean at all
times. Using a small brush, remove
the lint that accumulates in the shuttle
area and around the feed dogs.

Fig. 2 Parts of the Shuttle Assembly

To Clean the Shuttle Area:

1. This area must be kept free of dust,

lint and occasional tangled thread.

Raise the needle bar to its highest

point and remove the bobbin case.

2.

Push levers of shuttle race aside

and lift shuttle race cover and shut­
tle out.

3.

Clean the shuttle race with small

brush.

4.

Put a drop of oil on the center pin

of

the

shuttle

and

shuttle

race,

(see arrows)

To Replace Shuttle Assembly:

1.

Position shuttle race as illustrated

so that shuttle driver is forming

half moon on the left side of the

machine.

2.

Hold shuttle by center pin and po­

sition shuttle so as to form a half

moon on the right side. Pointed

hook will be on the bottom.

3.

Place shuttle race cover into place

over shuttle assembly.

Fig. 2

41

This manual is related to the following products: