Brother FAX-210 - Manual (Page 50)

G. Remote Operation of the Message Center
The messages recorded on your FAX-210 Message Center can be retrieved from any touch-
tone telephone, provided, you know the 2-digit security code. To do so, press "9" when you
hear the OGM (your Outgoing Message) or Call Message.
1 . Dial the telephone number of your FAX-210 unit.
2. When you hear the OGM , press "9" repeatedly until you hear a short beep (1 second).
3. Dial in the 2-digit Security Code within 15 seconds of hearing the beep. If the code is
correct, you will hear a short beep (1 second). If the code is incorrect, you will hear a
series of short beeps. Try again!
Now, you are ready to request the FAX-21 0's Message Center to perform some functions.
These functions and the remote commands needed to activate them are shown in the table
below.
41
FUNCTION COMMAND DESCRIPTION
Play back message/memo 9 + 22
Pressing "2" while a message/memo is being played will bring you forward to the next
message/memo.
Pressing "3" while a message/memo is being played will erase the message/memo being
played.
Erase all message/memo 9 + 25
Record memo 9 + 36
Record/Change OGM 9 + 46
Playback OGM 9 + 42
FAX message count 9 + 52 Maximum of 255 messages are
counted.
The counter is cleared each time the
unit is set to Message Center.
VOICE message count 9 + 53 Counts the number of ICM/memo in
Message Center.
Message Center ON 9 + 62 Turns Message Center on.
Message Center OFF 9 + 63 Turns Message Center off.
Auto Paging ON 9 + 72 Turns Auto Paging on.
Auto Paging OFF 9 + 73 Turns Auto Paging off.
Terminate Remote Control 9 + 88 Terminates the operation. If you do
not order this termination, the unit
will cut the connection automatically
in 30 seconds unless you issue
another command.
NOTE 1 : if there are no messages on your Message Center and you try to play back or erase
ICMs, you will hear a series of short beeps.
NOTE 2: A short beep is heard repeatedly for 30 seconds when each function has been
completed. To continue with another function, press "9" within 30 seconds after a
1 sec. beep.
The FAX MESSAGE COUNT is a feature unique to Brother. Its main purpose is to save you a
trip to check on the arrival of that important fax message you've been waiting for. When the
FAX message count command is entered, as many number of short beeps as fax messages
received will be heard. If the count is zero, there is no need to rush back.