beautypg.com

Kenmore 385.16120200 User Manual

Page 72

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

(3) Mark for placement of buttonhole
@ Starting point
(5) Slider
(6) There should be no gap.
(7) Spring holder
(8) Difference

Draw both threads to the left under the foot.
insert the garment under the foot, and iower the needle at

the starting point.
Then iower the automatic buttonhole foot.

*Make sure there is no gap® between the siider® and

the spring holder®, if there is a gap®, the length of
the rows will be different, as shown in®.

Sew slowly and stop the machine at the starting point when
a buttonhole is completed.

Remove the fabric and place a pin just before the bartack at

each end to prevent cutting bartacks. Cut the opening with
the buttonhole opener.

After a buttonhole is sewn, move the stitch to c::: by
turning the stitch selector, then return the stitch back to
“ y ” to reset for sewing the next buttonhole.

When finished, push the buttonhole lever up as far as it will
go.

64