beautypg.com

Threading the machine, Drawing up bobbin thread, Serging – Kenmore 385.16120200 User Manual

Page 32

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Threading the Machine
• Threading the machine

* Raise the thread take-up lever to its highest position by

turning the handwheel counterciockwise.

* Raise the presser foot lifter.
* Place a spool on the spool pin, with thread coming off as

shown.

Q] Draw the end of thread around the upper thread guide.

^ While holding the thread near the spool, draw the end of

the thread down around the check spring holder.

Firmly draw the thread up from right to left over the
take-up lever and down into the take-up lever eye.

0 Slide the thread behind the needle bar thread guide on

the left.

^ Thread the needle from front to badi or use a needle

threader.
We recommend using the convenient needle threader
(#200262101), included with your machine.

• Drawing up bobbin thread

|1] Raise the presser foot. Hold the needle thread lightly

with your ieft hand and rotate the handwheel counter
clockwise, toward you, for one complete turn.

[

2

] Bring the bobbin thread up by pulling the needle thread

up.

] Pull both threads under and to the back of the presser

foot, leaving 4 to 6 inches (10 cm to 15 cm) of thread
clear.

24