Kenmore 385.16120200 - Manual (Page 14)

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
CD Power suppiy plug
(2) Power switch
(D Outlet
(4) Machine socket
(5) Machine piug
® Light buib
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
eiectricai power.
1. Turn off the power switch (2).
2. Insert the machine plug® into the machine socket (3).
3. Insert the power supply plug (T) into the outlet @.
4. Turn the power switch @to turn on the power and
sewing light®.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
oN
Operating Instructions:
“For appliances with a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the piug. if it still
does not fit, contact a qualified electrician to install the
power outlet. Do not modify the piug in any way.”
“Foot Controller Model YC-482J-1 orTJC-150 is used with
Sewing Machine Model 385.15516XXX.”
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.