GE C2S985SETSS - Manual (Page 55)

GEAppliances.com
Problem Possible Causes What To Do
Oven not clean after
a clean cycle Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled. • Clean up heavy spillovers before starting the clean cycle.
Heavily soiled ovens may need to self-clean again or
for a longer period of time.
"LOCK DOOR" flashes
in the display The self-clean cycle has been • Close the oven door,
selected but the door is not closed.
LOCKED DOOR light
is on when you want
to cook
The oven door is locked • Touch the Clear/Off pad. Allow the oven to cool,
because the temperature inside
the oven has not dropped below
the locking temperature.
"E—and a number or
letter^’ flash in the
display You have a function error code. • Touch the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes and
then reconnect power. If the function error code
repeats, call for service.
“Probe" appears in
the display
This is reminding you to enter • Enter a probe temperature,
a probe temperature after
plugging in the probe.
Display goes blank A fuse in your home may be • Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the • See the Special features of your oven control section,
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the
display to show “SE"
Oven control pads were • The Bake and Broil Hi/Lo pads must be touched at
not pressed properly. the same time and held for 3 seconds.
Power outage,
clock flashes Power outage or surge. • Reset the clock. If the oven was in use, you must reset
it by touching the Clear/Off pad, setting the clock
and resetting any cooking function.
"Burning" or "oily"
odor emitting from
the vent
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time. minimum of 3 hours. See the Using the self-cleaning
oven section.
Strong odor An odor from the insulation • This is temporary,
around the inside of the oven
is normal for the first few times
the oven is used.
LOC appears in display The Gas/Control Lockout feature • Be sure the surface burner controls are turned OFF.
is activated Turn this feature off to use the range. See the
Gas/Control Lockout section.
55