Using the self-cleaning upper oven, How to delay the start of cleaning, After a clean cycle – GE C2S985SETSS User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Using the self-cleaning upper oven.
The oven door must be closed and all controls set correctly for the cycle to work properly.
S
elf
C
lean
0
0
0
0
E
0
0
0
0
0
CownoL Loam/r
D
elav
S
tart
How to Delay the Start of Cleaning
Make sure the clock shows the correct time of
day.
rj]
On models with Gas/Control Lockout,
touch and hold the Gas/Control Lockout
pad for 3 seconds to turn it off.
NOTE: The surface burners must be turned off
prior to the self-clean start time.
If your model has a latch, latch the door.
01 01 01 0] ®
Touch the Se//^C/eon pad.
H
0
0
0
0
0
S
tart
Using the number pads, enter the desired
clean time.
Touch the Delay Start
pad. The earliest
start time you can set will appear in the
display.
Using the number pads, enter the time of
day you want the clean cycle to start.
~y] Touch the Start
pod.
On models without a door latch, the door locks
automatically. The display will show the start
time. It will not be possible to open the oven
door until the temperature drops below the
lock temperature and the LOCKED DOOR
light
goes off.
d
The oven shuts off automatically when the
clean cycle is complete.
When the LOCKED DOOR
light is off, slide
the latch handle to the left as far as it will
go and open the door. If your range does
not have a latch, the door will unlock
automatically.
I The words LOCK DOOR
will flash and the
oven control will signal if you set the clean
cycle and forget to close the oven door or
forget to latch the door on models with a
latch.
I To stop a clean cycle, touch the Clear/Off
pad. When the LOCKED DOOR
light goes
off, indicating the oven has cooled below the
locking temperature, unlatch the door (on
models with a latch) and open the door.
After a Clean Cycle
You may notice some white ash in the oven.
Wipe it up with a damp cloth after the oven
cools.
If white spots remain, remove them with a
soap-filled scouring pad and rinse thoroughly
with a vinegar and water mixture.
These deposits are usually a salt residue that
cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle,
repeat the cycle.
I You cannot set the oven for cooking until the
oven is cool enough for the door to unlock.
I While the oven is self-cleaning, you can
touch the CLOCK
pad to display the time
of day. To return to the clean countdown,
touch the COOKING TIME
pad.
I If the racks become hard to slide, apply a
small amount of vegetable oil or cooking oil to
a paper towel and wipe the edges of the oven
racks with the paper towel.
28