Cisco 7200 VXR User Manual
Cisco 7200 vxr routers
Table of contents
Document Outline
- Cisco 7200 VXR Routers
- 1 Documentation and Resources
- 2 Prepare for Installation
- 3 Rack-Mount the Router
- Brackets Front-Mounted-Chassis Protrudes from the Rack
- Brackets Front-Mounted-Chassis Recessed in Rack
- NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a Front-Mounted Router
- Brackets Rear-Mounted-Front Protrudes from the Rack
- Brackets Rear-Mounted-Front Recessed in the Rack
- NPE-G1 or NPE-G2 Rear Cable-Management Brackets on a Rear-Mounted Router
- NPE-G1 or NPE-G2 Optical Cable-Management Bracket
- Two-Post or Four-Post Rack Installation
- Install the Chassis Ground
- 4 Connect the Router to the Network
- 5 Start and Configure the Router
- Power Cable Connections
- Important NPE-G1 and NPE-G2 Information
- Start the System and Perform a Basic Configuration
- Perform a Basic Configuration Using the Setup Facility
- Configuration Information for the NPE-G1 or NPE-G2
- Configure an Auxiliary Port to Receive Console Port Messages for the NPE-G1 or NPE-G2
- Configure the Native Gigabit Ethernet Interfaces on the NPE-G1 or NPE-G2
- Change the Media Type of the Native Gigabit Ethernet SFP, GBIC, or RJ-45 Ports
- Configure the Interface Transmission and Speed Modes for the NPE-G1 or NPE-G2
- Debug the NPE-G1 or NPE-G2
- Reset the Interface on the NPE-G1 or NPE-G2
- Clear Counters on the NPE-G1 or NPE-G2
- Configure Interfaces
- Save the Running Configuration to NVRAM
- Check the Running Configuration Settings
- View Your System Configuration
- Perform Complex Configurations
- Replace or Recover a Lost Password
- 6 After Installation
- Replace the Network Processing Engine or Network Services Engine
- Replace the I/O Controller
- Replace the PC Card, Flash Memory Card, Flash Disk, CompactFlash Disk, or USB Token
- Replace the Gigabit Interface Converter
- Replace the SFP-NPE-G2
- Installing a USB Flash Memory Module or eToken-NPE-G2
- Replace a Port Adapter or Service Adapter
- Replace the Port Adapter Jacket Card
- Replace the Power Supply
- 7 Cisco Product Security Overview
- 8 Obtaining Technical Assistance