Cisco 7200 VXR User Manual

Page 28

Enter enable secret: barney

The enable password is used when there is no enable secret password and when using older software and

some boot images.

Enter enable password: betty

Enter virtual terminal password: fred

Step 6

The Simple Network Management Protocol (SNMP) is the most widely supported open standard for network
management. It provides a means to access and set configuration and run-time parameters of routers and
communication servers. SNMP defines a set of functions that can be used to monitor and control network elements.

Enter yes or press Return to accept SNMP management; enter no to refuse it:

Configure SNMP Network Management? [yes]:

Community string [public]:

Step 7

For the following queries, do not enable VINES, LAT, DECnet, CLNS, bridging, XNS, or Apollo:

Configure Vines? [no]:

Configure LAT? [no]:

Configure DECnet? [no]:

Configure CLNS? [no]:

Configure bridging? [no]:

Configure XNS? [no]:

Configure Apollo? [no]:

Step 8

For the following queries, enable routing on AppleTalk and IPX:

Configure AppleTalk? [no]: yes

Multizone networks? [no]: yes

Configure IPX? [no]: yes

Step 9

In most cases, you use IP routing. If you are using IP routing, you must also select an interior routing protocol. You can
specify only one of two interior routing protocols to operate on your system using the setup facility: Interior Gateway
Routing Protocol (IGRP) or Routing Information Protocol (RIP). To configure IP routing, enter yes (the default) or press
Return, and then select an interior routing protocol:

Configure IP? [yes]:

Configure IGRP routing? [yes]:

Your IGRP autonomous system number [1]:

The following sample display includes a continuous listing of all configuration parameters selected in Step 4 through
Step 9. Only IP, IPX, and AppleTalk are the selected protocols for this example.

Configuring global parameters:

Enter host name [Router]: router

The enable secret is a one-way cryptographic secret used instead of the enable password when it exists.

Enter enable secret: barney

The enable password is used when there is no enable secret and when using older software and some boot

images.