AvMap EKPIV series - Manual (Page 72)

7
point. The following options assist in getting the most track memory for your type of flying.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “TRACK SETUP” + ‘ENTER’ +
“TRACK RECORDING STEP” + ‘ENTER’
distance - will store a fix point at the specified interval of distance.
time - will store a fix point at the specified interval of: 5 sec, 30 sec, 1 min.
Auto - this allows for the most efficient use of the memory as the software will determine when to
store a fix point based on straight and curved flight paths.
The default setting is Auto.
14.4.6 Clear track
Deletes all of the Track history and begins new.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “TRACK SETUP” + ‘ENTER’ +
“CLEAR TRACK” + ‘ENTER’
After pressing ‘ENTER’ a window appears; press ‘ENTER’ to confirm deletion or ‘CLEAR’ to abort
function. The message “DONE” will appear confirming the action.
14.4.7 Remaining track
The remaining track memory is displayed on the Track Setup Menu page. The number displayed
will be points, time, or distance based on the recording step selection.
14.5 UnItS Set-UP
This sub-menu contains the various options that define how the EKP-IV displays units of
measurement.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “UNITS SETUP” + ‘ENTER’
14.5.1 date & time Set-up
These functions control how the EKP-IV displays time and date settings.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “DATE & TIME SETUP” + ‘ENTER’
14.5.1.1 time Format
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “DATE & TIME SETUP” + ‘ENTER’ +
“TIME FORMAT” + ‘ENTER’
Using the cursor key select the desired setting and press ‘ENTER’.
Time can be displayed as 4/UTC (Zulu time), 1 hour or 4 hour local time. The default setting is
4/UTC. If you select a local time display, continue with the next step.
14.5.1.2 Local time difference
If you select local time above, you must key in an offset from UTC. The correct time difference must
be entered to calculate the local time.
> ‘MENU’ 1 sec. + “SYSTEM SETUP” + ‘ENTER’ + “DATE & TIME SETUP” + ‘ENTER’ +
“LOCAL TIME DIFFERENCE” + ‘ENTER’
After pressing ‘ENTER’ a window appears; using the cursor key, select the difference between local
time and UTC to the nearest 30 Minutes. Press ‘ENTER’ to activate.