Avlink MRM-602P - Manual (Page 40)

M M M R R R M M M - - - 6 6 6 0 0 0 2 2 2 P P P
39
APPENDIX A IR CONTROLLER
The MRM-602P Switcher supports a remote controller allows you to remote switch which
Input signal by passing through to current output with an extended connection - IR
receiver/transmitter. The signal for controller is only available to the IR receiver
connected to the IR hole located on the rear panel.
Channel Port selection:
Press the Number#1~6 button to select the channel that you want to appear on the
output displayer.
Example: Press the “5” button on the Remote controller specified the input signal of the
channel comes from the INPUT5 interface source.