Avlink 3SC-02MW User Manual
Sd/hd/3g-sdi to cvbs conversion box, Introduction, Features
SD/HD/3G-SDI to
CVBS Conversion
Box
3SC-02MW
U
SER
M
ANUAL
V1.0
3SC-02MW
Package Contents-
1 3SC-02MW Unit
1 User manual
1 Power adapter DC 12V
2
Screws
4 foot pads
1 Terminal Block
Any thing missed, please contact with your vendor.
Introduction
The 3SC-02MW Component SD-SDI、HD-SDI or 3G-SDI to
CVBS and S-video of conversion box.
Features
Support SD /HD /3G-SDI standard formats.
Equalized Looping SD/HD/3G-SDI output.
Additional 2 Channel RCA jack audio output.
AUTO SD/HD/3G-SDI input detection.
Analog and Coaxial audio output supports.
Specifications
SDI Input
1 x BNC
SDI Output
1 x BNC
CVBS Output
Connector
1x RCA
S-Video Output
Connector
1 x mini-DIN 4 Female
Analog Audio
Connector
2 x RCA
Coaxial (S/PDIF) Audio
Connector
1 x RCA
RS-232 Connector
1 x 3-pin Terminal Block
Select Switch
4
Input SDI support
625i@50
720p@50/59.94/60
1080i@50/59.94/60
[email protected]/24/25/29.97/30
1080p@50/59.94/60
Output video support
[email protected] (NTSC)
625i@50 (PAL)
Analog audio support
sample rate
48kHz
Digital audio support
sample rate
48kHz
100m (Max.) for input port
SDI Cable Distance
(Single end)
10m for output port
Input Signal Type
Standard SD/
HD/3G-SDI
Signal
Power Adapter (Min.)
DC 12V
Housing Metal
Weight 480g
Dimensions (LxWxH)
171x119x25mm
Note:
Different cable qualify might effect upon the maximum
resolution and cable distance.
-1-
FRONT VIEW
1. RS232 control Port
Rx pin: connect the RxD pin of the RS232 from PC
Tx pin: connect the TxD pin of the RS232 from PC
GND pin: connect the GND pin of the RS232 from PC
2. “S-Video Out” Port
3. “CVBS Out” Port
4.
OSD “MENU” Button (start / close OSD)
5.
OSD “DOWN” Button
6.
OSD “UP” Button
7.
OSD “ENTER” Button
8.
Power LED
REAR VIEW
1. 3G-SDI Input port
2. 3G-SDI output port
3. Coaxial audio output port
4. Analog audio output port
5. Input Power Jack
Installation
1. Connect the 3SC-02MW video input BNC connector
with SDI cable from different audio/video equipment.
2. Connect the RCA cable between the monitor and the
“CVBS” port of 3SC-02MW; or connect the S-Video
cable between the monitor and the “S-Video” port of
3SC-02MW.
3. Connect the power cord and turn on the 3SC-02MW.
4. Turn on the SDI video source device.
-2-