ALTANA Cloud-Runner Manual - Manual (Page 35)

34
Configuration
9.1 Number of Measurements
This function allows selection of the numbers of
readings to be taken per sample. If the number is
greater than 1, the measurements are statistically
evaluated. Turning the scroll wheel adjusts the
number while pressing it shifts the decimal place
one further over. Pressing operate completes the
process and a confirmation display appears.
9.2 Scanlength
The scanlength is adjustable between 10 and 100
cm in 1 cm steps to your individual needs. The little
black triangle shows the position to be adjusted.
Turn the mode wheel to adjust or press the wheel to
proceed to the next position. Pressing operate
completes the process and a confirmation display
appears.
You can enter the scanlength alternatively by
pressing the operate button and by moving the
instrument over the surface to be scanned. Keep
the operate button pressed until the desired length
is reached. Then release the operate button. The
scanlength is displayed and you can confirm it by
pressing operate again.
Note:
Using a short scanlength will result in strong
statistical skewing of measurement values for large
mottle sizes (for minimum scan length please see
also under 9.4).
9.3 Angles
Three angles may be selected for the display of the
measurement results.
Select the desired angle and press the operate
button. A checkmark indicates the selected
angle(s).