AERCO CXT-E Retrofit Kit - Manual (Page 4)

ECS and CXT-E Retrofit Instructions Kit # 27004-TAB
Technical Instruction Document TID-0141_0A
12/30/2014 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, New York 10913 • Phone: 800-526-0288 Page 4 of 76
1.3 RETROFIT KIT CONTENTS
The contents of the Retrofit Kits, Part No. 27004-[ ] are included in Appendices A through D of
this document. The contents included in these Appendices are as follows:
•
Appendix A: Lists the Basic ECS Retrofit Kit contents for each Water Heater Model
•
Appendix B: Lists Optional Items based on: valve size, flow rate, type of actuator
currently installed
•
Appendix C: Lists Valve Kits required for previously installed Pneumatic and Electro -
Hydraulic Actuators
•
Appendix D: Lists Valve Kits required for previously installed Self-Contained Actuators
WARNING!
HIGH VOLTAGE OF 120 VAC IS USED IN AERCO INDIRECT
FIRED WATER HEATERS. USE EXTREME CARE WHEN
ACCESSING CIRCUITS AND ELECTRICAL CONNECTIONS
WITHIN THE EQUIPMENT. SERIOUS PERSONAL INJURY OR
DEATH MAY OCCUR IF THIS WARNING IS NOT OBSERVED.
FOLLOW OSHA APPROVED LOCKOUT/TAGOUT PROCDURES.