AERCO BMK 1.5 LN Dual Fuel Jan 2009 - Manual (Page 57)

TROUBLESHOOTING
Chapter 8- TROUBLESHOOTING GUIDE
8.1 INTRODUCTION
This troubleshooting guide is intended to aid
service/maintenance personnel in isolating the
cause of a fault in a Benchmark 1.5 Dual-Fuel
Boiler. The troubleshooting procedures con-
tained herein are presented in tabular form on
the following pages. These tables are com-
prised of three columns labeled: Fault Indica-
tion, Probable Cause and Corrective Action.
The numbered items in the Probable Cause and
Corrective Action columns correspond to each
other. For example, Probable Cause No. 1 corre-
sponds to Corrective Action No. 1, etc.
When a fault occurs in the Benchmark Boiler,
proceed as follows to isolate and correct the
fault:
1. Observe the fault messages displayed in the
Control Box display.
2. Refer to the Fault Indication column in
Troubleshooting Table 8-1 which follows and
locate the Fault that best describes the
existing conditions.
3. Proceed to the Probable Cause column and
start with the first item (1) listed for the Fault
Indication.
4. Perform the checks and procedures listed in
the Corrective Action column for the first
Probable Cause candidate.
5. Continue checking each additional Probable
Cause for the existing fault until the fault is
corrected.
6. Paragraph 8.2 and Table 8-2 contain
additional troubleshooting information which
may apply when no fault message is
displayed.
7. If the fault cannot be corrected using the
information provided in the Troubleshooting
Tables, contact your local AERCO
Representative.
8-1