A&D Weighing AD-4407 - Manual (Page 24)

Page 22 AD-4407 Weighing Indicator
6. 6. 6. 6. Functions Functions Functions Functions
There are two parameters lists, one for the F-functions and one for the CF-functions.
These functions control the indicator. The parameters of each function are stored in
the non-volatile memory, and are not lost even if power is turned off or cut off.
F-functions: These parameters can always be changed and are used for internal settings.
CF-functions: If you accept a certificated approval of the weighing instruments, the CAL
cover (rear panel) must be sealed. Therefore, accepting this approval, the
parameters of the CF-function can not be changed.
6.1. 6.1. 6.1. 6.1. Changing the Function Settings Changing the Function Settings Changing the Function Settings Changing the Function Settings
To enter the function settings, do either of the following.
1. When the display is off, press the ON/OFF key while pressing the +/- key.
2. When in the weighing mode, press both the +/- and ON/OFF keys at the same time.
When you are in the function setting, f00 will be displayed .
Operating Item
Step 1
Select an item using the 0 - 9 keys.
ENTER key The key to display a parameter of
the selected item.
Proceed to step 2.
ESC key To exit from functions and enter
the weighing mode.
CAL key The key to exchange F-functions
and CF-functions.
Operating parameter
Step 2
Select a parameter using the 0 - 9 keys.
ENTER key The key to store a parameter
and return step 1.
ESC key The key to return step 1
without changing the
parameter.
CLEAR key Changes the display to the
default value.(Type1)
Changes the sub item.(Type2,
Type3) Type2 and Type3 are
indicated in the parameter table.
Exit function setting
Press
ESC key to go to the weight display when an item number is displayed.
6. Functions
Weighing
Weighing
+/ +/ +/ +/- -- -
NET/GROSS
PRINT
ENTER
PRINT
ENTER
PRINT
ENTER
PRINT
ENTER
TARE
ESC
9 0
9 0
+/ +/ +/ +/- -- -
NET/GROSS
PRINT
ENTER