KEYENCE IV-M30 - Manual (Page 7)

7
IV Series (Monitor) - IM_E
z „ Connecting via network
Connect each Ethernet cable to the monitor and sensor.
Connect the other side of the Ethernet cable to the Ethernet
switch.
Ethernet cable
(2m/5m/10m)
Ethernet switch
For details on connecting the Ethernet cable, refer to
“Connecting the monitor cable/Ethernet cable” (Page 7).
The sensor and monitor do not support PoE
(Power over Ethernet). Supply power using
the power cable.
z „ Connecting the monitor cable/Ethernet cable
This section describes the details on connecting the monitor
cable/Ethernet cable using the example of connecting the
monitor cable to the sensor.
1
Align the pin connection parts of the monitor
cable/Ethernet cable connector with three pins of
the cable connector, and connect the cable to the
sensor.
Align the pins and
the pin connection
* Same procedures for monitors.
2
Tighten the connector by turning the screw-
on connector in the clockwise direction. When
connecting the connector, insert it without
inclination while pushing in and tighten it well.
(1)
Tighten the screw.
(2)
When the screw stops rotating by the locking
mechanism, further tighten it while pushing.
* Same procedures for monitors.
Repeat the steps (1) and (2) and when you cannot
tighten the screw by hand any more, use a tool such as
pliers for further tightening. Tightening torque, retorque
degree, and acceptable spaces between connectors are
shown below.
y Monitor cable/Ethernet cable
(OP-87450/OP-87451/OP-87452/OP-87453/
OP-87457/OP-87458/OP-87459)
Tightening torque : 0.8 to 1.0 N·m
Retightening degree : 5 to 10°
Spaces between connectors (reference value)
For sensors : 0 mm
For monitors : 2.2 mm
If the connector cable tightening is weak,
vibration may loosen the connector and cause
bad connections or cable disconnections.
Also, the enclosure rating may not be
maintained with loose connection.
Properly follow the procedures above and
tighten the connector completely.
Check the spaces between the monitor cable/
Ethernet cable and the cable connector.
Spaces between
connectors
z z For sensors
Spaces between
connectors
z z For monitors