KEYENCE CV-X Series - Manual (Page 7)

KEYENCE CORPORATION. Vision System Division ‐ 7 ‐ www.keyence.com
1
✎
Checking the Global Settings of the CV-X Series
On the "Global" menu, select [Communications & I/O] > [PLC-Link].
2
Select "OK" to close the "PLC-Link" setting screen and then restart the controller.
Configure the PLC‐Link settings.
Mode: PLC- Link (RS- 232C)
PLC Type: SYSMAC CJ/CS1/CP1 Series
Baud Rate: 115200
Stop Bit: 1
Parity Bit: Even
Flow Control: None
Data Length: 8- bit (fixed)
* The above is a setting example. Change
the settings according to the target device.
Decimal Point: Fixed- point
Command Execute Event: Polling
Command Complete Address (bit): 00003
Command Address: 00100
Command Result Address: 00200
Result Output Address: 00500
Result Ready Address (bit): 00000
Result Ack Address (bit): 00001
Acknowledge result output completion:
Checked
Enable Handshake: Unchecked
2. Establishing the PLC-Link
(RS-232C PLC-Link) [SYSMAC CJ Series]
This section describes how to establish the PLC‐Link.
[Important] If it fails, follow this manual to configure the settings and check the operations.
Confirm that it operates properly, and change settings if necessary.