KEYENCE CV-X Series - Manual (Page 14)

KEYENCE CORPORATION. Vision System Division ‐ 14 ‐ www.keyence.com
4. Controlling the Controller
(PLC-Link) [SYSMAC CJ Series]
1
✎
Checking the Global Settings of the CV-X Series
On the "Global" menu, select [Communications & I/O] > [PLC-Link] to open the global "PLC-Link" settings
screen.
2
Check the setting items necessary for controller control.
Select the Command Execute Event.
Select Polling for Command Execute Event.
3
Select "OK" to close the global "PLC-Link" settings screen.
Check the data memory to use for the following three items.
‐ Command Address
‐ Command Complete Address (bit)
‐ Command Result Address
The data memory address to use can be changed.
Be careful not to specify an address of a data memory being used for another program of PLC.
* The screen on the left shows that
Mode is set to "PLC‐ Link (Ethernet)",
but the settings (in the red frame) in
this section (Controlling the
Controller) are the same as those of
"PLC‐ Link (RS‐232C)".