Holtgreven Truck Scale Resources - Manual (Page 22)

PT300 Users manual
Rev G, Feb 2011
Page 22 of 44
function, meaning the scale will never shut itself off. Use the LOCAL/TOTAL button the
advance the number and the ZERO button to move the number flashing to the left. When
the display shows the desired number, press the PRINT/ACCUMULATE button.
8. The display will show “Prt t Prt t Prt t Prt t”. Press the PRINT/ACCUMULATE button. The flashing digit
shows the current setting. The number enables the scales different print modes. (0 for on-
demand, 1 for continuous, 2 for accumulating total axle format, and 3 for accumulating total
standard format) Use the LOCAL/TOTAL button to increment and the ZERO button to
decrement the number. When the display shows the desired number, press the
PRINT/ACCUMULATE button.
9. The display will show “PbAUd PbAUd PbAUd PbAUd”. Press the PRINT/ACCUMULATE button. The flashing
display shows the current setting of the printer baud rate. The baud rates available are:
1200, 2400, 4800, 9600, 19200, 38400, 57600, and 115200. Use the LOCAL/TOTAL
button or the ZERO button to toggle through the available rates. When the display shows
the desired number, press the PRINT/ACCUMULATE button.
10. The display will show “UnitS UnitS UnitS UnitS”. Press the PRINT/ACCUMULATE button. The lb or the kg
icon will flash in the upper left of the display. This will set the scale to measure pounds (lb)
or kilograms (kg). Use the LOCAL/TOTAL button or the ZERO button to toggle between
the settings. When the desired icon is flashing, press the PRINT/ACCUMULATE button.
11. The display will show “Proto Proto Proto Proto”. Press the PRINT/ACCUMULATE button. The flashing
display shows the current setting. There are 4 protocol settings for the scale, Standard
(“StAnd
StAnd StAnd StAnd”), Low Power (“Lo Pr Lo Pr Lo Pr Lo Pr”), Current Loop (“C CC C.L00P L00P L00P L00P”), or “None None None None” .
Standard is a setting for use in specific wireless and wired scale networks. Low Power
will significantly improve the wireless battery life for all non-‘host’ scales (maximum number
of scales in this mode is 32).
Current Loop is used when connecting to older legacy PT300 scales. The legacy cables
(part #’s 100488, 100489, or 100490) must be used when in this communication mode.
See section titled “Totalizing/Printing in Current Loop Mode” for more information.
When scales are not part of a totalizing network, battery life will be improved if “nonE nonE nonE nonE” is
chosen. Use the LOCAL/TOTAL button or the ZERO button to cycle through the settings.
When the desired protocol is flashing, press the PRINT/ ACCUMULATE button.
12. The display will show “i ii i.bAud bAud bAud bAud”. Press the PRINT/ACCUMULATE button. The display will
show the current setting flashing. This is the setting of the interface baud rate. There are
two settings available, 9600 and 115200. Use the LOCAL/TOTAL button or the ZERO
button to toggle between the settings. When the desired baud rate is flashing, press the
PRINT/ ACCUMULATE button.
13. The display will show “rAdio rAdio rAdio rAdio”. Press the PRINT/ACCUMULATE button. The display will
show the current setting flashing. This is the radio enable status and is either on or off.
Use the LOCAL/TOTAL button or the ZERO button to toggle between the settings. When
the desired status is flashing, press the PRINT/ ACCUMULATE button. If you select “no”
the scale will skip the rest of the settings and return to normal weighing.