Hardy WS100 Configuration Software - Manual (Page 10)

Chapter 2 - Requirements
2-1
CHAPTER 2 - REQUIREMENTS
General Introduction
to Chapter 2 All the information in Chapter 2 pertains to the hard-
ware and software requirements for HI WS100 Con-
figuration Software. These requirements are the
minimum requirements for loading and operating HI
WS100 Configuration Software. Check to see if the
personal computer on which you want to install HI
WS100 Configuration Software, meets these require-
ments. It is very important that the user be familiar
with this section before installing or operating this
software.
Operating System
Requirements HI WS100 Configuration Software runs on the fol-
lowing operating systems:
• Windows NT 4.0/2000
• Windows 95/98
Minimum Hardware
Requirements HI WS100 Configuration Software requires
the following hardware:
• CPU - Pentium
®
133 MHz or better
• 3 MB free space on your hard drive
• RAM - 16 MB
• Monitors - SVGA, configured for 640 x 480
resolution or better
• Floppy Drive - 3.5”, 1.44 MB drive or better
NOTE: The HI WS100 must run in conjunction with Allen
Bradley’s RS LINX or RS LINX LITE therefore the HI
WS100 hardware requirements are in addition to
hardware requirements for RS LINX or RS LINX
LITE.
Software
Requirements Allen Bradley’s RS LINX
®
or RS LINX
®
LITE soft-
ware.
RSLogix OR EQUAL
(FOR REMOTE MODE
OPERATION ONLY) Allen Bradley’s RSLOGIX
®
software or equivalent.
NOTE: RSLOGIX
®
is a registered trademark of the Rockwell
Corporation.