Hardy ANY-WEIGH Bench Scales User Manual
Hardy Scales

Any-Weigh™
BENCH SCALES
OPERATION AND INSTALLATION
MANUAL
Corporate Headquarters
9440 Carroll Park Drive, Suite 150
San Diego, CA 92121
Phone: (858) 278-2900
FAX: (858) 278-6700
Web-Site: http://www.hardyinst.com
Hardy Instruments Document Number: 0596-0268-01 Rev F
Copyright December 2002 Hardy Instruments, Inc. All Rights Reserved. Printed in the U.S.A. (941028)
Table of contents
Document Outline
- Any-Weigh™
- BENCH SCALES
- OPERATION AND INSTALLATION
- MANUAL
- Table of Contents
- Table of Illustrations
- Chapter 1 - overview
- chapter 2 - specifications
- chapter 3 - installation
- chapter 4 - configuration
- chapter 5 - Setup
- chapter 6 - calibration
- About Calibration of the DeviceNet, Analog and Universal Bench Scales
- C2 Second Generation Calibration
- Test Weight Calibration (Hard Cal)
- Material Substitution
- Universal Scales HI SBU Series
- DeviceNet Scales HI SBD Series
- THE BUTTON®
- C2® Calibration from RS NetWorx®
- Test Weight Calibration from RS NetWorx®
- Analog Scales HI SBA Series
- chapter 7 - OPERATION
- chapter 8 - Troubleshooting
- SCOPE
- Problem:
- Scale Does Not Respond When Weight is Applied
- Scale Indication is not linear
- Scale Reads Backwards
- Scale Reading drifts or is Erratic
- DeviceNet Scale: Module LED does not Come Back on When Performing Calibration with The Button
- DeviceNet Scale: Module LED is Flashing Red
- Analog Scale: Malfunction, No Output
- Analog Scale: No Change in Input
- Analog Scale: Output Drifts
- Service and Repair (All Models)
- Index