Checkline Series-5 User Manual

Page 26

Series 5 Digital Force Gauges

User’s Guide

Use the UP and DOWN keys to select the correct password, then press ENTER to continue.

If the incorrect password has been entered, the display will appear as follows:

To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and
enter the password again when prompted.

If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The
request code

must be supplied to Mark-10 or a distributor, who will then provide a corresponding

authorization code

. Enter the activation code to disable the password.

12 OTHER SETTINGS

12.1 Automatic Shutoff
The gauge may be configured to automatically power off following a period of inactivity while on battery
power. Inactivity is defined as the absence of any key presses or load changes of 100 counts or less. To
access these settings, select Automatic Shutoff from the menu. The display will appear as follows:

Select Disabled to disable automatic shutoff. Select Enabled to enable it. The length of time of inactivity
is programmed in minutes via the Set Minutes parameter. Available settings: 5-30, in 5 minute
increments.

Note: If the AC adapter is plugged in, the gauge will ignore these settings and remain powered on until
the POWER key is pressed.

12.2 Backlight
Although the backlight may be turned on and off at any time by pressing the BACKLIGHT key, there are
several available initial settings (applicable upon powering on the gauge). To access these settings,
select Backlight from the menu. The display will appear as follows:

AUTOMATIC SHUTOFF

Disabled

Enabled
Set Minutes

INCORRECT PASSWORD

Reset password

Request code:

XXXX

Press ENTER or ESC